Turn the power off, unplug the power cable and wait 60 seconds. Make sure the console cable is not pinched or damaged in any way.Ĥ. Unplug and reconnect the console cable to verify.ģ. Double check that all connections are secure, especially the console cable. Inspect the heart rate receiver to insure that grounding wire is attached. There may be an improper grounding of the heart rate receiver. They are typically found at department stores or treadmill specialty stores. Place a rubber mat under the treadmill to reduce the static carried from the carpet. Use humidifier to increase humidity in the air.ĥ. Some shoes seem to add to static shocks.Ĥ. Use an anti-static spray on clothing and/or around treadmill.ģ. Wear cotton clothing to reduce static on the body.Ģ. Symptom : Excessive static electricity/erratic heart rate readings.ġ. Static electricity can damage the heart rate grip receiver and/or grips and cause either an “HR” or no reading at all. Rather, try holding the grips for 10-20 seconds at a time for an accurate reading.Ĥ. Contact heart rate grips are not intended for continuous reading. Try gripping the handlebar contacts over the top, with your thumb next to your index finger instead of gripping it with your thumb under the handlebars.ģ. Before taking pulse, stop walking and step on side rails and place hands on contacts.Ģ. Press the quick speed key that you want and then the Enter or Confirm button to select that speed or incline. The 2007 treadmills have a two-touch speed and incline function. Troubleshoot/Repair : If only the quick keys are not working ![]() The ribbon cable should fit snugly into place. The ribbon cable is a thin clear cable with white stripes that connects to the bottom of the upper board. Verify that the ribbon cable (picture below) connections are properly and securely in place. From the top of the console, gently lift the console faceplate and electronics from the console housing.Ĥ. Remove screws that hold the console electronics to the console housing (picture below).ģ. Wait 60 seconds, allowing lower board to discharge built up energy.Ģ. ![]() Troubleshoot/Repair : Upper Board Ribbon Cable Connectionsġ. Plug in the treadmill and recheck console keys. While standing on both side rails, firmly massage over all keys in a circular motion.ģ. Symptom : All or some of the keys on the console do not work.Ģ. Tip: Don’t forget to review the Advantages and Disadvantages according to Spine-Health to select the right and affordable treadmill for you in 2021. Verify that all wires are securely and correctly placed on the lower circuit board, especially the large wire harness on the top of the circuit board with 12 different colored wires coming out of it. Verify that there are no lights lit on the lower circuit board.ĥ. Wait 60 seconds, allowing the lower board to discharge built-up energy.Ĥ. Unplug the treadmill from the wall outlet. Unplug and reconnect the console cable to verify.Ģ. ![]() Symptom : The elevation function is not working properlyġ. If the upper board still displays dashes then replace upper board. Short the switch connector on the upper board by using a flat blade screwdriver or by placing a jumper switch on the connector.Ģ. Possible cause #1 : Safety key is positioned incorrectly or has failed.ġ. Symptom : Console only displays dashes in the display window – Magnet style key.
0 Comments
Leave a Reply. |